To Visi t Furman* Click Below
This is only a Partial Listing of Power Conditioning & Equalization Products Available
If you don't see what you are looking for please Call:
781-449-1005
Or
E-mail:
*The link above will take you from the "You-do-it" Electronics Website. You may encounter Sites which use cookies. Please use these links @ your own risk. Although every effort has been made to check the content of the sites above,"You-do-it" Electronics cannot be responsible for content contained in the websites which are linked above.
|
"You-do-it" Electronics Center ® | home
Furman Index | Furman AC-215, AR-1220 | AR-15II, AR-PRO | M-8X, M-8D, MP-15 | PL-8II, PL-PLUSDII, PL-PLUSII | PL-PRODII, PL-PRODM,PL-PROII | ACX-1, ADP-1520, PLUGLOCK, PS-8R, RS-1, SS-4 FURM, SS-6B, GN-LED | SB-1000
D10-PFP YDI Price $34.50
M-8D YDI Price $99.00
M-8X YDI Price $49.90
|
Models and Ratings
D10-PFP Features
• 10 rear panel outlets
• Sturdy one rack space design
• 15 amp capacity with circuit breaker
M-8D Features
• Filtration of noise from radio frequencies and electromagnetic interference
• Standard level of surge suppression
• Digital LED voltmeter to display incoming line voltage
• Dual pull-out rack lights with dimmer control
• 8 rear panel outlets
• Sturdy one rack space design
• 15 amp capacity with circuit breaker
M-8X Features
• Filtration of noise from radio frequencies and electromagnetic interference
• Standard level of surge suppression
• 8 rear panel outlets
• Sturdy one rack space design
• 15 amp capacity with circuit breaker
|
Specifications:
Maximum output current:
15 amps (1800 watts at 120 VAC)
Line Cord:
6 ft. captive, 14 AWG, with three conductor Edison plug
Lamps:
2 x 7 wa
AC Voltmeter (if present):
Range 60 to 150 VAC; Accuracy +/- 2 VAC
Spike Protection Mode:
Line to neutral
Clamping Voltage:
Maximum surge current:
Maximum spike energy:
102 joules
Noise attenuation:
Transverse mode: Greater than 20 dB, 1.5 to 200 MHz
Dimensions:
.75" H x 19" W x 7.5" D with light tubes in; when fully extended light tubes reach 3.5" from front panel surface
Weight:
5 lbs (2.3 kg)
Construction:
Steel chassis, black painted
Power Consumption:
14 watts if lamps are present
Safety Agency Approvals:
RR-15, RR-15NL: NRTL/TUV
|
MP-15 YDI Price $99.00
|
Miniport 15
The MINIPORT-15 Power Relay is a UL/CUL listed, 15 amp, relay switched 120 VAC outlet, with a terminal strip that allows remote control via safe, inexpensive, low voltage Class 2 wiring. This model includes an internal 12 VDC supply, and can be controlled from a remote location with maintained or momentary contact switches.
Multiple MINIPORTs may be connected together so that all are controlled by a single switch closure, and may be linked so that all turn on simultaneously or one by one, in a delayed sequence. If delayed, the delay interval between the turn-on of one MINIPORT and the next is approximately 3 seconds. (Delayed turn-on is useful in avoiding large inrush currents that can trip house circuit breakers, that would otherwise occur if all amps were turned on simultaneously.) Turn-off always occurs simultaneously, however.
A Furman PowerLink can also be used to control MINIPORT(s). In this use, the MINIPORT(s) areconnected to terminals on the PowerLink, which provide the necessary control functions. MINIPORTs are similarly compatible with the Furman PowerPort and ASD-120 Sequenced Power Distro. With the addition of a PS-REL AC Relay to provide control, a MINIPORT can be used to extend the capacity of any other Furman power product — or, for that matter, any product with a switched outlet, such as a receiver/ amp controlled with a wireless remote. When used in this manner, the MINIPORT is switched on or off when the outlet that the PS-REL is plugged into goes on or off.
The MINIPORT-15 comes equipped with two knockout holes for permanent installation with 1/2" conduit — one on the top surface, the other on the bottom. Use of the bottom knockout hole requires removing the AC cord. According to the National Electrical Code, 1/2" conduit can accommodate up to five 20 amp circuits using ten THWN 12 gauge stranded wires; however, local codes should be checked for exact requirements.
MINIPORTs are housed in rugged steel enclosures and come equipped with a heavy duty, 10 foot AC cord. The MINIPORT-15 is fused. The MINIPORT-15 is UL and CUL (Canadian) listed.
Dimensions: 5.5" (H) x 3.75" (W) x 2" (D). With mounting bracket, width is 5.25".
|
Many other Brands & Types of Power Conditioners & Rack Mount Products Are Available!
Bring your Friends & Family to Visit America's Unique Electronic Store.
Prices current . Prices are9/29/2008 subject to change without notice. The products listed on our website are typically stocked by "You-do-it" Electronics Center. We try to maintain a current listing ofproducts stocked . Occasionally products which are discontinued may be listed on our website.
Please E-mail Sales@youdoitelectronics.com or Call for current availability. Prices are subject to change without notice. All orders are subject to acceptance by this company & our Vendor in accordance with its standard acknowledgement form. All prices are subject to all applicable State and/or Local sales taxes. Terms are MasterCard, Visa, Discover, or American Express or Check with order, unless other arrangements are made with our credit department.
|
|